Basic System Configuration Using An N/Na; (S )-Type Cpu Unit - Omron CP1E-E14SDR-A User Manual

2-1-2

Basic System Configuration Using an N/NA

The system configuration when using a CP1E N/NA
Battery
CP1W-BAT01
Support Software
Personal computer
CX-Programmer
IBM PC/AT or equivalent
Programmable
Terminal (PT)
(NT Link/Host Link)
General component Inverter
(No-protocol mode)
(Modbus-RTU)
CP-series PLC or
CJ1M PLC Host computer
(Host Link)
(Serial PLC Link)
Precautions for Correct Use Precautions for Correct Use
For CP1E CPU Units, the following I/O memory area will be unstable after a power interruption.
• DM Area (D) (excluding words backed up to the EEPROM using the DM function)
• Holding Area (H)
• Counter Present Values and Completion Flags (C)
• Auxiliary Area related to clock functions(A)
Mount the CP1W-BAT01 Battery (sold separately) to an N/NA
data in the above areas need to be retained after a power interruption. A Battery cannot be
mounted to an E
CP1E CPU Unit Hardware User's Manual(W479)
2 Basic System Configuration and Devices
CP1E CPU Unit Expansion I/O Units
CP1E-N30D -
20 or 40 I/O Points
CP1E-N40D -
CP1E-N60D -
8 inputs
CP1E-NA20D -
8 outputs
16 outputs
32 outputs
CP1E-N30S(1)D -
CP1E-N40S(1)D -
CP1E-N60S(1)D -
RS-232C Option Board
CP1W-CIF01
CP1E-N14D -
CP1E-N20D -
COMM
(S)-type CPU Unit.

(S )-type CPU Unit

(S )-type CPU Unit is shown below.
Expansion Units
Analog I/O
Analog inputs
Analog outputs
Temperature sensors
CompoBus/S I/O Link Unit
Up to 3 Units can be connected
*Neither the CP1W-DAM01 LCD Option Board nor the CP1W-CIF41
Ethernet Option Board version 1.0 can be used.
RS-422A/485 Option Board
Or CP1W-CIF11
CP1W-CIF12
COMM
When a two level layout is created by expansion and distance is required
Expansion Units and
CP1E CPU Unit Expansion I/O Units
(S )-type CPU Unit if
DIN Track
Ethernet Option Board
Or CP1W-CIF41
(version 2.0 or higher)
IP ADDRESS:
SUBNET MASK:
COMM ERR 10BASE-T
100BASE-TX
I/O Connecting Cable
CP1W-CN811
2-3
2