Basic System Configuration; Basic System Configuration Using An E/S; Type Cpu Unit; Basic System Configuration Using An N/Na - Omron SYSMAC CP Series User Manual

2 Basic System Configuration and Devices
2-1

Basic System Configuration

This section describes the system configurations using CP2E CPU Units.
2-1-1

Basic System Configuration Using an E/S

The system configuration when using a CP2E E/S
Battery
CP2W-BAT02
(S -type only)
Support Software
Personal computer
CX-One
Serial port
Programmable
Terminal (PT)
(NT Link/Host Link)
General component Inverter
(No-protocol mode)
(Modbus-RTU)
CP-series PLC or
CJ2M PLC Host computer
(Host Link)
(Serial PLC Link)
2-2
CP2E CPU Unit
CP2E-E30DR-A
RS-232C port CP2E-E40DR-A
CP2E-E60DR-A
RS-485 port
CP2E-S30D -
CP2E-S40D -
CP2E-S60D -
CP2E-E14DR-A
CP2E-E20DR-A

-type CPU Unit

-type CPU Unit is shown below.
Expansion I/O Units Expansion Units
20 or 40 I/O Points
Analog I/O
8 inputs Analog inputs
8 outputs Analog outputs
16 outputs Temperature sensors
32 outputs
Up to 3 Units can be connected
When a two level layout is created by expansion and distance is required
Expansion Units and
CP2E CPU Unit Expansion I/O Units
CP2E CPU Unit Hardware User's Manual(W613)
DIN Track
I/O Connecting Cable
CP1W-CN811