(indexing function) • All parameters are set and maintained by a PLC or PC. • Up to 63 servos can be connected to the DeviceNet network • Supports polling I/O and explicit messages System configuration...
Parameters damage, parameter setting errors, communications errors, etc. LED indicators MS: Module status NS: Network status Note: *The allocation of the output signals for brake interlock, servo ready, or positioning completion can be changed using parameter settings. Transmission specifications Item Specifications...
Page 3
Nomenclature Ground wire Connected to ground mark on the servo drive Rotary switch (x1, x10) For node address setting Rotary switch (DR) For transmission speed setting RS-232C connector (CN11) For setup tool LED (MS) Module status LED (NS) DeviceNet network status...
1 Connect when using an absolute encoder and when the battery is not connected to CN8. 2 Set the signal assignment with the user constants. Note: Connect the ground cable of the field bus I/F unit to the ground connector of the servo drive. Motion controllers...
Connector for CN6. DeviceNet multi-branching XW4B-05C4-TF-D Connector with retaining screws Connector for CN6. DeviceNet multi-branching XW4B-05C4-T-D Connector (without retaining screws) Note: For a complete view of DeviceNet network accessories, refer to automation systems catalogue or contact your OMRON repre- sentative. Computer software Name Model...
Page 6
ALL DIMENSIONS SHOWN ARE IN MILLIMETERS. To convert millimeters into inches, multiply by 0.03937. To convert grams into ounces, multiply by 0.03527. In the interest of product improvement, specifications are subject to change without notice. Cat. No. I11E-EN-02 Motion controllers...