Rebooting The Router - HP A8800 Installation Manual

6
Table 10 Command output
Field
Slot No.
Brd Type
Brd Status
Software
Version

Rebooting the router

CAUTION:
Router reboot can interrupt network services.
•
To avoid data loss, use the save command to save the current configurations before a reboot.
•
Use the display startup and display boot-loader commands to check that you have correctly set the
•
startup configuration file and the main system software image file.
You can reboot the router in one of the following ways to recover from an error condition:
Reboot the device immediately at the CLI.
•
At the CLI, schedule a reboot to occur at a specific time and date or after a delay.
•
Power off and then re-power on the device. This method might cause data loss, and is the least
•
preferred method.
Reboot at the CLI is also called hot start. It is mainly used to reboot a router in remote maintenance,
without performing hardware reboot of the router.
For data security, if you reboot the router while the router is performing file operations, the router does
not reboot.
The precision of the rebooting timer is 1 minute. One minute before the rebooting time, the router
prompts "REBOOT IN ONE MINUTE" and reboots in one minute.
To reboot a router:
NONE Absent
Description
Slot number of a card.
Hardware type of a card:
Specific card model, such as SPE-1010-II, which is the same as the mark on the card.
• NONE—No card is in the slot.
• UNKNOWN—The card is not supported by the software version and cannot start
normally.
Card status:
• Absent—No card is in the slot.
• Master—The card is an AMB.
• Slave—The card is a SMB.
• Normal—The card is an interface card and operates properly.
• Fault—The card in the slot has not started or fails.
• Off—The card is not powered on.
Software version of the current card:
• Specific software version—The software version of the router.
• NONE—No card is in the slot.
• Mismatched—The software version does not support the card and thus cannot be
uploaded.
NONE
34