Installing an NEPS1800-A AC power supply
Pull the handle of the power supply downward to the unlock position.
1.
Gently push the power supply into the AC power frame (NEPS3500-A) until the rear side of the
2.
power supply makes close contact with the power frame backplane.
Push the handle upward so that it locks the power supply in place.
3.
Figure 12 Installing an AC power supply
Installing a card
All cards (excluding subcards) for the routers are hot-swappable.
You install MPUs and LPUs in the same way.
To prepare for installation:
Put on an ESD-preventive wrist strap and make sure it is properly grounded.
1.
Remove the blank panel (if any) from the slot to be used. Keep the blank panel and protection
2.
cover for future use
Prepare the card to be installed.
3.
To install a card:
Remove the protection cover before installing the card:
1.
Put on an ESD-preventive wrist strap, and then use a Phillips screwdriver to loosen the
a.
captive screws that fasten the card to the protection cover.
Gently pull the card out of the protection cover, as shown in
b.
14
Figure
13.