Installing a transceiver module
CAUTION:
During installation, do not touch the golden finger of the SFP module.
The installation procedures for an XFP module and SFP module are similar. The following procedure
uses an SFP module as an example.
To install an SFP module:
Put on an ESD-preventive wrist strap, and make sure it makes good skin contact, and is well
1.
grounded.
Unpack the SFP module. Close the clasp by pushing it up over the SFP module, and then gently
2.
insert the SFP module into the interface slot until it clicks into place, as shown in
Figure 26 Installing an SFP module
IMPORTANT:
Do not remove the dust plug of the SFP module port before installing an optical fiber.
•
For an SFP module installed with an optical fiber, remove the fiber before you install the SFP module
•
into the slot.
Connecting an optical fiber
Put on an ESD-preventive wrist strap, and make sure it is well grounded.
1.
Remove the protective cap from the fiber connector, and use dust free paper and absolute
2.
alcohol to clean the end face of the fiber connector.
Connect one end of the fiber to the SFP module of the router.
3.
Connect the other end of the fiber to the peer device.
4.
30
Figure
26.