Installing an impedance carrier (optional)
An impedance carrier is shipped with the A8808 only. You can install the impedance carrier at the
rear of the chassis (where an air filter is located) to block the airflow from entering the rear of the
chassis.
Install an impedance carrier for routers that have front-to-rear airflow, as shown in
To install an impedance carrier:
Loosen the captive screws on the air filter to remove the air filter.
1.
Install the impedance carrier, and fasten the captive screws on the impedance carrier.
2.
Figure 7 Installing an impedance carrier
Installing the router to a rack
CAUTION:
Make sure you have installed a rack shelf or slide rails on the rack for supporting the router, and the
•
rack shelf or the slide rails are sturdy enough to support the weight of the router chassis and all
accessories. Do not install the router to the rack using only mounting brackets.
To install multiple routers on the rack, mount the heaviest router at the bottom of the rack.
•
To mount the router in the rack:
Use several people to place the router on the rack shelf or slide rails, and then slide the router
1.
into the rack until the mounting brackets on the router touch the front rack posts.
Fasten the mounting brackets to the rack posts with mounting screws, as shown in
2.
the screw holes on the mounting brackets cannot align with the cage nuts on the rack, verify
10
Figure
7.
Figure
8. If