Settings; Initial Operation - Otto Bock ParaGolfer Instructions For Use Manual

7
6
5
4
3
2
1
17
Fig. 2 Main components of the ParaGolfer
1 Footplate
2 Charging receptacle
3 Brake release lever
4 Knee belt with knee pad
5 Lateral pads
6 Control panel
7 Seat cushion
8 Lap belt
9 Chest belt
ParaGolfer
9 8
16 15
10 Backrest
11 Armrest
12 Storage compartment
13 Stand-up device
14 Cover
15 Rear wheel
16 Drive wheel
17 Chassis with motor, controller,
battery and fuse
4.2

Settings

The following tools are required to adjust the wheelchair to
10
the requirements of the user and for maintenance work:
„ Allen wrenches, sizes 3, 4, 5, 6
„ Open-end or combination wrenches, sizes 8, 10
11
„ Phillips screwdriver
12
13
„ Screwdriver for pan head screws
14
„ Tyre repair accessories
4.3

Initial operation

WARNING
Risk of suffocation. Packaging materials must be kept
out of reach of children.
All components must be checked for completeness and
functionality prior to initial operation.
Before the sports wheelchair can be switched on, the fuse
must be inserted into the fuse holder which is located later-
ally underneath the seat, next to the left drive wheel (see
fig. 3). To do so, remove the fuse from the protective cover
on the control panel, open the cap of the fuse holder and in-
sert the fuse. It is important to make sure that the fuse is in-
serted into the centre of the spring contacts and that it is not
at an angle.
Delivery and preparation for use
Ottobock | 27