Additional Options; Control Panel Holder - Otto Bock Juvo Instructions For Use Manual

Hide thumbs Also See for Juvo:
Table of Contents

Advertisement

Use
74
Retrieving/exiting "I/O Module 1"
The environmental control mode for devices with infrared remote control is retrieved/exited as follows:
Repeatedly pressing the [Profile/mode] button retrieves the profiles and operating modes in succession (see
Page 30; dependent on programming).
When "I/O Module 1" mode is reached, the programmed building services devices can be wirelessly con­
trolled (see below).
Pressing the [Profile/mode] button again allows you to switch to further operating modes and back to the driv­
ing profiles again (dependent on programming).
LCD display in "I/O Module 1" mode – TEN° control panel
Display
Operating devices
75
Function 1
Function 4
Left
Function 2
Function 2
Function 2

6.16 Additional options

6.16.1 Control panel holder

Swing-away control panel holder
The control panel holder makes it possible to drive the power wheelchair under a table or closer to an object.
The control panel holder can be rotated up to the armrest.
86
Information
"I/O Module" mode active
The devices being controlled must be synchronised with the control unit prior to use.
Synchronisation is performed by the qualified personnel.
Function 5
Right
Function 3
Function 6
An additionally available wireless module makes it pos­
sible to control up to 6 building services receivers
(e.g. outlets, light switches, roller shutters etc.) wire­
lessly via the control panel.
Operating in the background, the wireless module is a
transmitter (frequency 868.30 MHz), which uses the
Easywave protocol especially developed for building
services. This protocol is used in numerous building
services products available in the market.
The maximum tested driving distance range is 20 m.
The devices being controlled must be synchronised
with the control device prior to use. Synchronisation is
performed by the qualified personnel.
The desired function can be controlled in "I/O Module
1" mode by moving the joystick in the corresponding
direction.
Example: Function 1 is started by moving the joystick
forwards.
Juvo

Advertisement

Table of Contents
loading

Table of Contents