Pots Interface: Pabx - AVT MAGIC TH6 POTS Hardware & Software Manual

O p e r a t i o n v i a W i n d o w s
POTS
P A G E 6 4
P C S o f t w a r e
5.6.4.2.4

POTS Interface: PABX

NOTE
This menu can only be displayed if you are working with a MAGIC TH6
POTS system and the POTS operating mode is selected (see CHAPTER
5.6.4.2.2, Page 60).
FIG. 41
POTS: PABX
Under Country Setting you can select which country-specific POTS interface
you use.
NOTE
This setting is important for the Audio quality. The impedance of the POTS
interface may vary from country to country and the Echo Canceller of the sys-
tem can only work correctly if the right Country Setting is selected.
If your PABX has been manufactured in a different country, you should also
try the origin country as Country Setting.
TIP
If you want to connect the TCU-100/121 GSM Adapter (ID: 490135) to one of
the POTS interfaces of MAGIC TH6, please select GSM Adapter: TCU-100E
as Country Setting.
• The function Wait for received phone number (CLIP) before call in sig-
nalling allows you to decide whether you want to see an incoming call im-
mediately displayed or if you want to wait until the telephone number of
the caller is transmitted. The signalling of the telephone number will take
2 - 3 ringing tones.
• If you want to drop the connection when the system detects a busy tone on
the called end, you can select Drop when busy tone detected.
• Under Loop-Break Timeout you must select the time the system needs to
eliminate loop-break disturbances to answer a call. Usually, values from
300 msec to 500 msec should be sufficient. If you have problems with these
values, you should select a higher one.
• The Hook Flash Duration depends on your PABX or outside line and is
required for call forwarding.
POTS INTERFACE: PABX