AVT MAGIC TH6 POTS Hardware & Software Manual page 59

Display
• The Display has a backlight. Under the setting Backlight you can switch
it ON permanently. If you select the option Auto the backlight is turned off
automatically 60 seconds after the last keystroke. The backlight is acti-
vated again by pressing any key (e.g.
NOTE
Please note that if the keypad lock is activated, the backlight is only switched
on after pressing the key sequence
• Via the slide control Contrast you can adjust the contrast for the display
within the range 0 ... 15. The default setting is
PC control via RS232/Keypad 2
• If you want to operate the system with the PC via RS232 or you want to use
a MAGIC TH6 Keypad on the RS232 interface 2, you must set the data rate
in accordance with the interface. There are five baud rates available: Key-
pad (9600 Baud, None), PC (19200 Baud, None), PC (38400 Baud,
None), PC (57600, None) and PC (1152000, None).
NOTE
The MAGIC TH6 Keypad supports only the baud rate 9600 Baud. Therefore,
please select the option Keypad (9600 Baud, None) if you use a keypad.
If you connect a PC via the RS232 interface, the selected baud rate must cor-
respond with the baud rate of the COM interface (CHAPTER 5.6.3, Page 41).
Please note that the LAN interface is deactivated if you use the RS232 inter-
face for PC control.
System Name
• Under Name you can assign a name to your system.
O p e r a t i o n v i a W i n d o w s
Ok
).
Menu *
.
P C S o f t w a r e
.
0
P A G E 5 9