Night Service Button; Load Preset Button; Reset Dtmf Button - AVT MAGIC TH6 POTS Hardware & Software Manual

NOTE
To configure Pretalk Streaming for your PC-Client, you need to select an IP
Stream as Pretalk source for your PC under Operation Settings
Audio Line (see CHAPTER 5.6.4.1.1, Page 44) and configure the Audio in-
put/output for Pretalk Streaming under Local Settings
ing (see CHAPTER 5.6.7.2, Page 81). Here you can also select where you want
to save the recordings. Please ensure also that the correct Pretalk Steraming
Udp ports are entered under System Settings
CHAPTER 5.6.4.2.8, Page 70).
5.5.1.11

Night Service button

The Night Service button is only available if you have configured the Night
Service under Operation Settings
5.6.4.1.6, Page 52). If the Night Service is switched on, calls will be automati-
cally forwarded to a preselected phone number. To switch it off, press the
Night Service button again or use the Switch Off button of the Night Service
window.
FIG. 19
5.5.1.12

Load Preset button

After selecting the LOAD PRESET button a list of all available Presets will be
displayed. If a Preset is selected, the corresponding configuration will be
loaded in MAGIC TH6.
5.5.1.13

Reset DTMF button

The RESET DTMF button is only displayed if the fee-based option DTMF
Tone Analyzer Plug-In (ID: 430441) is available and if you have selected
Standard or Game Show under Configuration
details you will find in CHAPTER 6, Page 93.
O p e r a t i o n v i a W i n d o w s
→
NIGHT SERVICE SWITCHED ON
P C S o f t w a r e
→
Mode &
→
Pretalk Stream-
→
LAN Interface (see
Night Service (see CHAPTER
→
DTMF Settings. Further
P A G E 3 9