AVT MAGIC TH6 POTS Hardware & Software Manual page 56

O p e r a t i o n v i a W i n d o w s
P A G E 5 6
P C S o f t w a r e
Under POTS Line/ISDN Line you select if you want to signal the status
of Line 1, Line 2, Line 3, Line 4, Line 5, Line 6 or all lines (Any). If you
select Any, the signal is set on the TTL Pin as soon as one of the lines
has the predefined status.
– Audio Line: With this function you can signal when a caller is switched
to a certain Audio line. Please select under Audio Line the desired Au-
dio line. Under POTS Line/ISDN Line you select if you want to signal
the status of Line 1, Line 2, Line 3, Line 4, Line 5, Line 6 or all lines
(Any). If you select Any, the signal is set on the TTL Pin as soon as one
of the lines has been set to the predefined Audio line.
– ON AIR: If you select this function, it is signalled when a caller is
switched to ON AIR. Under POTS Line/ISDN Line you select if you
want to signal the ON AIR status of Line 1, Line 2, Line 3, Line 4, Line
5, Line 6 or all lines (Any). If you select Any, the signal is set on the TTL
Pin as soon as one of the lines is switched to ON AIR.
– PRETALK: If you select this function, it is signalled when a caller is
switched to Pretalk. Under POTS Line/ISDN Line you can select if you
want to signal the Pretalk status of Line 1, Line 2, Line 3, Line 4, Line 5,
Line 6 or all lines (Any). If you select Any, the signal is set on the TTL
Pin as soon as one of the lines is switched to Pretalk.
– Ringing/Connected State: Toggeling of voltage when a call is coming
in (e.g. for flashing light). When the connection is established, the TTL
Pin is set.
– Called Number:
– Information Base Entry: Special function for projects.
– Any System Alarm Pending: This function signals any system alarm.
– Application Alarm Pending: If you enable this function, you can select
under Alarm which Application Alarm you want to signal.
– DTMF Digit Received:
– ON AIR by Terminal:
If you select the option Inverted, which is displayed next to the function code,
the inverted signal is transmitted.
Relay
ATTENTION Please pay attention to the maximum switch current of 200 mA respectively
the maximum switch voltage of 48V per relay output.
!
The following description applies for the configuration windows Relay 1, Re-
lay 2, Relay 3 and Relay 4.