AVT MAGIC TH6 POTS Hardware & Software Manual page 46

O p e r a t i o n v i a W i n d o w s
P A G E 4 6
P C S o f t w a r e
Audio Line Assignment
• Under Audio Line Assignment you can assign the Audio interfaces to the
ON AIR, PRETALK and HOLD.
• In the column Name you can see which name is displayed on the front dis-
play of MAGIC TH6 if the corresponding Audio line has switched a caller
to Pretalk, On Air or Hold.
• The column Audio Line shows the available Pretalk and On Air Audio
lines (ON AIR 1...6, PRETALK PC 1 ...4, PRETALK KEYPAD 1, 2 and
HOLD/Monitoring). If a caller is switched to one of these Audio lines by a
user, the other users who are working with the PC Software will see the
corresponding name displayed on the Pretalk and ON AIR buttons.
Example: User 1 is working with the Audio line PRETALK PC 1. If he
switches a caller to Pretalk, user 2 who is working with a second PC will
see PRETALK PC 1 displayed on the Pretalk button. On the front display
PRE4
of the system
• In the column Audio Interface you can select which Audio interface is to
be assigned to which Audio line. If you do not want to use an Audio line,
select Not used in the column Audio Interface. The following Audio in-
terfaces can be selected:
– Handset 1 (only for Pretalk)
– Handset 2 (only for Pretalk)
– XLR Analogue 1
– XLR Analogue 2
– AES/EBU 1 left
– AES/EBU 1 right
– AES/EBU 2 left
– AES/EBU 2 right
– IP Audio Stream 1...4 (only for Pretalk; Pretalk Streaming Upgrade
(ID: 430464) required)
• If you have selected a digital Audio line for ON AIR, PRETALK or HOLD,
you can decide not to receive an alarm if there is no Audio signal available
at the AES/EBU input. In this case, please enable No Input Alarm.
• To allow a control unit - external Keypad or PC - to put the callers to On
Air, please enable the checkbox ON AIR Access.
• If you want to assign a different name to the Audio line to be displayed in
the PC Software, you can enter a new name under Custom Label.
• To select the default settings for your selected operating mode, please click
on Default Settings. For safety reasons you must confirm that you really
want to select the default settings.
will be shown.