AVT MAGIC TH6 POTS Hardware & Software Manual page 42

O p e r a t i o n v i a W i n d o w s
P A G E 4 2
P C S o f t w a r e
The standard IP Address of the system is 192.168.96.66 and the standard
control Port 10000.
To enable a connection with your PC, you have to be in the same subnet.
Therefore, please enter an IP address from your subnet
(Dynamic Host Configuration Protocol) to get the correct settings automati-
cally (if a DHCP Server is available) (see CHAPTER 5.6.4.2.8, Page 70).
To change the IP address on the front keypad of the system, press the softkey
→
Menu system settings
desired IP address. When entering it manually you have to be sure that the IP
address is not already used by another unit
Please enter the correct IP address of the system under IP Address and the
correct Port under Port.
TIP
The currently allocated IP address of the system can be displayed by pressing
the telephone button
rently no Audio connection is established.
RS232
If you want to use the RS232 interface, connect the serial RS232 interface via a
1:1 connecting cable with your PC. Please select now under Interface
RS232. Under Parameter
nected with the system and under Mode the desired Baud rate must be con-
figured.
If the selected COM port is already busy, an error message will be displayed.
Then select another open COM port. The default Baud rate in the system is
38400 Baud.
FIG. 24
NOTE
Instead of the PC you can also connect the optional MAGIC T6 Keypad to the
serial interface of the system (see CHAPTER 7, Page 97).
1
In this way you can find out your own subnet: Under Windows XP click on Start
Enter cmd in the command line. An entry window is displayed in which you must enter ipconfig.
Your IP address is displayed (e.g. 192.168.12.35). Your subnet is accordingly 192.168.12.xxx.
2
To check if the IP address is already used in the network, follow the instructions: Under Windows
XP click on Start
in which you must enter ping xxx.xxx.xxx.xxx. Whereas xxx stands for the IP address you want
to check.
→
LAN settings
on the front keypad of the system twice if cur-
→
Port the COM Port of your PC, which is con-
RS232 PARAMETER.
→
Execute .... Enter cmd in the command line. An entry window is displayed
1
or activate DHCP
→
IP Address
. Enter now the
2
.
→
Execute ....
→