3-D Radius Compensation Depending On The Tool's Contact Angle (Option 92) - HEIDENHAIN TNC 640 User Manual

13
Multiple-Axis Machining | Peripheral Milling: 3-D radius compensation with M128 and radius compensation
3-D radius compensation depending on the tool's
contact angle (option 92)
Application
The effective sphere radius of a radius cutter deviates from the
ideal form owing to the production process. The maximum form
inaccuracy is defined by the machine tool builder. Common
deviations lie between 0.005 mm and 0.01 mm.
The form inaccuracy can be saved in the form of an compensation
value table. This table contains angle values and the deviation from
the nominal radius R2 measured on the respective angle value.
The 3D-ToolComp software option (option 92) enables the control
to compensate the value defined in the compensation value table
depending on the actual contact point of the tool.
3-D calibration of the touch probe can also be carried out with the
3D-ToolComp software option. During this process the deviations
determined during touch probe calibration are saved to the
compensation value table.
Further information:
(option 92)", page 714
Requirements
To be able to use the software option 3D-ToolComp (option 92) the
control requires the following preconditions:
Option 9 is enabled
Option 92 is enabled
The DR2TABLE column in the TOOL.T tool table is enabled
The name of the compensation value table (without its
extension) is entered in the DR2TABLE column for the tool to be
compensated
0 is entered in the DR2 column
NC program with surface normal vectors (LN blocks)
Compensation value table
If you create the compensation value table yourself, proceed as
follows:
In the file manager open the path TNC:\system
\3D-ToolComp
Press the NEW FILE soft key
Enter the file name with extension .3DTC
The control opens a table containing the required
columns for a compensation value table.
The compensation value table contains three columns:
NR: Consecutive line number
ANGLE: Measured angle in degrees
DR2: Radius deviation from the nominal value
The control evaluates a maximum of 100 lines in the compensation
value table.
592
"3-D calibration with a calibration sphere
HEIDENHAIN | TNC 640 | ISO Programming User's Manual | 10/2017
(G41/G42)