HEIDENHAIN TNC 640 User Manual page 420

10
Group Gruppen-
name nummerID
Status of execution
992
420
Systemdaten- Index
nummer
16 0
1
19 -
10 -
11 -
12 -
14 -
16 -
17 -
18 -
Programming Q Parameters | Additional functions
Description
0 = Transfer control over the channel spindle
to the PLC,
1 = Assume control over the channel spindle
0 = Pass tool spindle control to the PLC,
1 = Take control of the tool spindle
Suppress touch prove movement in cycles:
0 = Movement will be suppressed (CfgMa-
chineSimul/simMode parameter not equal to
FullOperation or Test Run operating mode is
active)
1 = Movement will be performed (CfgMa-
chineSimul/simMode parameter = FullOpera-
tion, can be programmed for testing purpos-
es)
Block scan active
1 = yes, 0 = no
Block scan—information on block scan:
0 = Program started without block scan
1 = Iniprog system cycle is run before block
scan
2 = Block scan is running
3 = Functions are being implemented
–1 = Iniprog cycle was canceled before block
scan
–2 = Cancelation during block scan
–3 = Cancelation of the block scan after the
search phase, before or during the update of
functions
–99 = Implicit cancelation
Type of canceling for interrogation within the
OEM_CANCEL macro:
0 = No cancellation
1 = Cancellation due to error or emergency
stop
2 = Explicit cancellation with internal stop
after stop in the middle of the block
3 = Explicit cancellation with internal stop
after stop at the end of a block
Number of the last FN14 error
Real execution active?
1 = execution,
0 = simulation
2-D graphics during programming active?
1 = yes
0 = no
Generate graphics during programming (soft
key AUTO DRAW) active?
1 = yes
0 = no
HEIDENHAIN | TNC 640 | ISO Programming User's Manual | 10/2017