Any Desired Nc Program As Subprogram; Overview Of The Soft Keys - HEIDENHAIN TNC 640 User Manual

Hide thumbs Also See for TNC 640:

Table of Contents

Subprograms and Program Section Repeats | Any desired NC program as subprogram

Any desired NC program as subprogram

When you press the PGM CALL key, the control displays the

following soft keys:

Call an NC program with %

Select a datum table with %:TAB:

Select a point table with %:PAT:

Select a contour program with %:CNT:

Select an NC program with %:PGM:

Call the last selected file with %<>%

Select any NC program with G: : as a fixed cycle

Further information:

HEIDENHAIN | TNC 640 | ISO Programming User's Manual | 10/2017

Cycle Programming User's