Table of Contents
Advertisement
7. Firmly insert the tab on pad A into the slot on the grease tool and rotate the pad onto the tool as
shown here.
8. Hold the grease tool against the back of carriage rod A and smoothly slide it from right to left across
the carriage rod four times.
Caution: Do not slide the tool back and forth; dust may enter the print head and damage can occur.
9. Remove the stained pad from the grease tool.
10. Attach a fresh pad A to the grease tool.
11. Use one of the cleaning sticks to stir the grease in the container approximately 10 times. Then wipe
the tip of the cleaning stick on the edge of the container to remove the excess grease.
Note: Be sure to remove the excess grease from the cleaning stick or it may fall off the stick and
onto the platen or your media.
142
Advertisement
Table of Contents
