Table of Contents
Advertisement
Checking for Clogged Print Head Nozzles
Media Is Creased
If media loaded in your printer is creased, try these solutions:
• Check that the Feeding Tension and Feed Speed Limiter settings on the product control panel are
correct for the currently loaded media.
• If you printed thin media or media lengthened by water absorption at a high density take-up setting,
creases that look like this may appear in the media in the after heater:
Set the Take-up Tension setting to Manual and decrease the tension values, or print on thicker
media.
• If you printed thin media or media lengthened by water absorption, vertical creases that look like this
may occur between the pressure rollers:
157
Advertisement
Table of Contents
