Epson SureColor F9370 User Manual page 78

Setting
Platen Gap
Heating & Drying
Feeding Tension
Take-up Tension
Media Suction
Options
1.6
2.0
2.5
Heater Temperature
Drying Time Per Pass
Blank Area Feed
After Heater Feed
Lv1 to Lv8
Auto
Manual
0 to 10
78
Description
Select if print quality is unsatisfactory.
Select for most media; default setting.
Select only if printouts are scratched or
smudged. Choosing a larger gap than
necessary can cause ink stains inside
the product, reduce print quality, or
shorten product life.
Set from 86 to 131 °F (30 to 55 °C);
defaults to 122 °F (50 °C).
Set from 0 to 10 seconds. You can
maintain a constant drying time by
basing it on the media width.
Speeds up feeding of blank areas.
Select Quick, Standard, Slow, or
Slowest.
Select On to feed media to the after
heater after printing (if the media will be
cut before the next job starts).
Increase the value if creases appear in
media during printing.
Select for most media.
Select a value from Lv1 to Lv9.
Decrease the value if creases appear in
media during printing or ink adheres to
the back of the take-up roll. Increase the
value if thick media cannot be wound
correctly.
Select a value to increase the gap
between the print head and thin or
flexible media. If print quality is reduced
or media does not feed correctly, you
may need to lower the value.