Replacing The Chip Unit And Refilling Ink - Epson SureColor F9370 User Manual

• Do not place anything on the ink tank or subject it to strong impacts, or the ink tank could detach.
• Do not switch between High Density Black ink and Black inks in the same ink tank. You must contact
Epson Support to have a service engineer replace the type of ink being used in an ink tank.
• Epson recommends the use of genuine Epson ink packs.
• Epson cannot guarantee the quality or reliability of non-genuine ink. The use of non-genuine ink may
cause damage that is not covered by Epson's warranties, and under certain circumstances, may
cause erratic printer behavior.
• Information about non-genuine chip unit status may not be displayed, and use of non-genuine ink is
recorded for possible use in service support.
Warning: Should ink contact your skin or enter your eyes or mouth, immediately take the following
actions:
• If fluid contacts your skin, immediately wash it off using large volumes of soapy water. Consult a
physician if the skin appears irritated or discolored.
• If fluid enters your eyes, rinse them immediately with water. Failure to observe this precaution could
result in bloodshot eyes or mild inflammation. If problems persist, consult with a physician.
• If swallowed, do not induce vomiting and consult with a physician immediately. Inducing vomiting may
cause material to get in your windpipe and cause injury.
Parent topic:

Replacing the Chip Unit and Refilling Ink

Follow the steps here to replace the chip unit and refill the ink in your product.
Replacing the Ink and Chip Unit
99