Table of Contents
Advertisement
GEM5000 Gas Analyzer
6.11
Memory
The analyzer's memory is stored in a readings and configuration database. The analyzer
will prompt when its memory is full, and you will not be able to store any further readings.
Please download your readings via LSGAM or the Basic Download Software and then clear
the memory.
Note:
The analyzer should never be stored for prolonged periods with valuable data in
its memory. It is advisable to download all readings to LSGAM at the end of
each day's monitoring. To clear the memory, please refer to the LSGAM
operating manual.
6.12
Warning and error codes
When switched on the instrument will perform a predetermined self-test sequence taking
approximately ten seconds. During this time many of the instrument's working parameters
and settings are checked. If any operational parameters are out of specification or if the
pre-programmed recommended calibration/service date has passed, errors or warnings
may be displayed.
Note: For further information please refer to section '10.0 Problem Solving'.
7.0
Operator Settings
7.1 Menu key
The 'Menu' key enables the operator to select options to set up specific
parameters and perform operational tasks prior to sample readings being
taken or to view data and information stored in the instrument.
1) Select the 'Menu' key on the front of the analyzer and the following screen is
displayed:
2)
Press the relevant numeric key on the analyzer keypad to select the required option.
3)
To exit this menu, select the soft-key 'Exit' on the front of the analyzer and the
operator is returned to Main Gas Read Screen.
OMGEM5KN4.7.1
Page 21 of 70
Advertisement
Table of Contents
