How To Use The Control Keys - Notifier AFC-600 Operating Manual

How to Use the Control Keys

+RZWR8VHWKH&RQWURO.H\V
AFC-600 Operations PN 51033:A 3/8/99
Technical Manuals Online! - http://www.tech-man.com
The control panel provides five Control Keys: A
A A , S
LARM CTIVATE YSTEM
/ Use the
ACKNOWLEDGE STEP
trouble signals. When you press the
following:
• Silences the panel sounder
• Changes all active LED indicators from flashing to steady
• Sends an Acknowledge message to the History buffer and installed printers, CRT-2
terminals, and terminal mode LCD-80s
• Sends a signal to silence the sounders on the LCD-80 and ACS annunciators
You can also press the
ACKNOWLEDGE
more than one alarm or trouble exists, the control panel displays the next alarm or
trouble for 3 seconds (or until you press the
next alarm or trouble.
Use the
ALARM SILENCE
ALARM SILENCE
all audio and visual devices connected to Notification Appliance Circuits. When you
press the key, the control panel does the following:
ALARM SILENCE
• Turns off the panel sounder
• Turns off all silenceable output circuits
• Lights the
ALARM SILENCED
• Sends an Alarm Silenced message to the History buffer and installed printers,
CRT-2 terminals, and terminal mode LCD-80s
Use the
ALARM ACTIVATE ALARM ACTIVATE
outputs or to test notification appliances. To prevent accidental activation, you must
press the
ALARM ACTIVATE
key, the control panel does the following:
• Turns on all silenceable NACs
• Turns off the
ALARM SILENCED
• Sends a Manual Evacuate message to the History buffer and installed CRT-2
terminals, printers, and terminal mode LCD-80s
6<67(0 5(6(7
Use the
SYSTEM RESET
key, the control panel does the following:
SYSTEM RESET
• Turns off all alarm-activated control/relay modules, NAC circuits, and Panel Circuits
• Breaks resettable power to four-wire detectors
• Sends an "All Systems Normal" message to the History buffer, and installed CRT-2
terminals, and terminal mode LCD-80s
If any alarm or trouble exists after you press the
outputs, and panel audio and visual indicators will reactivate.
$03 (67
Use the
/ 7
LAMP TEST
When you press and hold the
• Lights all control panel LEDs
• Turns on the panel sounder
• Lights all segments of the LCD display
CKNOWLEDGE
R , and L T .
ESET AMP EST
key to respond to new alarm or
/
ACKNOWLEDGE STEP
/
ACKNOWLEDGE STEP
key to display multiple alarms or troubles. If
/
STEP
ACKNOWLEDGE
key to silence the panel sounder and turn off
LED
key to manually activate all programmed
key for 2 seconds. When you press the
LED
key to reset the control panel. When you press the
SYSTEM RESET
key to test the control panel LEDs and panel sounder.
key, the control panel does the following:
LAMP TEST
 +RZ WR 8VH WKH &RQWUROV
/S ,
TEP ALARM SILENCE
key, the control panel does the
key), then displays the
/
STEP
ALARM ACTIVATE
key, NACs, control
,
13