How To Operate The Atg-2; How To Select Tones For The Atg-2 - Notifier AFC-600 Operating Manual

ATG-2 Audio Tone Generator
AFC-600 Operations PN 51033:A 3/8/99
Technical Manuals Online! - http://www.tech-man.com
+RZWR2SHUDWHWKH$7*
Table 25 contains instructions for operating the ATG-2.
To
Select the paging channel
Verify the active channel
Page
Enable single-channel
operation
7DEOH  2SHUDWLQJ WKH $7*
+RZWR6HOHFW7RQHVIRUWKH$7*
The ATG-2 DIP switch—S1 located on the ATG-2 board shown in Figure 67—provides
switches for selecting output tones and setting operations. When finished setting
switches, check the ATG-2 for proper operation. Figure 67 shows the ATG-2 board
layout and identifies DIP switch S1 and resistor R134:
',3 6ZLWFK 6 IRU
FRQILJXULQJ WKH
$7*
)LJXUH  $7* &LUFXLW %RDUG /D\RXW
Do this
Press the switch to select the Evacuation
EVAC CHANNEL
(primary) channel; or press the
select the Alert (secondary) channel.
3$*( 6(/(&7
/(' RQ WKH VHOHFWHG FKDQQHO OLJKWV
Check the and
EVAC CHANNEL
Press the microphone switch and speak into the
microphone (loudly enough to light the green
LED).
Cut resistor R134 on the ATG-2 board (see
5HVLVWRU 5 ² &XW 5 IRU
VLQJOHFKDQQHO RSHUDWLRQ
Continued on the next page...
 9RLFH $ODUP 6\VWHPV
switch to
ALERT CHANNEL
VZLWFK ² 3XVK XQWLO WKH
LEDs.
ALERT CHANNEL
ON LINE
Figure 67
).
61