Atg-2 Audio Tone Generator; Atg-2 Overview - Notifier AFC-600 Operating Manual

 9RLFH $ODUP 6\VWHPV
$7*$XGLR7RQH*HQHUDWRU
1RWH
)RU PRUH LQIRUPDWLRQ RQ
$7* FRQILJXUDWLRQ UHIHU WR
WKH 9RLFH 0RGXOHV 6HFWLRQ RI
WKH $)& ,QVWDOODWLRQ
0DQXDO
60
Technical Manuals Online! - http://www.tech-man.com
$7*2YHUYLHZ
The ATG-2 provides user-selected tones for single or dual channel output. The ATG-2
provides several ways to page.
• Direct paging – The ATG-2 microphone with a button switch lets you page through
EVAC CHANNEL
used with an optional FFT-7, the ATG-2 also lets you page through the system
from telephones installed throughout the installation.
• Remote paging microphone – You can also set up the ATG-2 to pass-through an
audio message or tone received from another AMG-1 or ATG-2. In this
configuration, the ATG-2 serves as an alternate (remote) paging location for the
AMG-1 or main ATG-2. The ATG-2 provides override paging capabilities from the
ATG-2 microphone. All communications go through NAC 1 using ACS mode
connected to the control panel unless set up for remote paging microphone
operation. For instructions on ACS mode, refer to the AFC-600 Installation
Manual.
Figure 66 shows the operating features of the ATG-2:
0LFURSKRQH
6ZLWFK
0LFURSKRQH
Table 24 contains descriptions of the four LEDs:
LED
LED
ON LINE
EVAC CHANNEL
ALERT CHANNEL
LED
TROUBLE
(primary) and
ALERT CHANNEL
3$*( 6(/(&7
VSHDNHU FLUFXLWV RQ RQH WZR RU ERWK FKDQQHOV
6\VWHP 6WDWXV
,QGLFDWRU /('V
)LJXUH  2SHUDWLQJ )HDWXUHV RI WKH $7*
Color Lights to show
green The ATG-2 is properly connected to the control
panel.
green Paging will take place over the
(primary). Produces a slow whoop, Hi/Lo, or steady
tone.
green Paging will take place over the
(secondary). Produces a chime or a
20 pulses-per-minute tone.
yellow A trouble in local audio subsystem equipment
(AMG-1, AA-30, FFT-7).
7DEOH  $7* /('V

ATG-2 Audio Tone Generator

(secondary) speaker circuits. If
VZLWFK ² OHWV \RX SDJH WKURXJK
EVAC CHANNEL
ALERT CHANNEL
AFC-600 Operations PN 51033:A 3/8/99