How To Operate The Amg-1 - Notifier AFC-600 Operating Manual

AMG-1 and AMG-E Audio Message Generator
AFC-600 Operations PN 51033:A 3/8/99
Technical Manuals Online! - http://www.tech-man.com
+RZWR2SHUDWHWKH$0*
Figure 61 shows the AMG-1 operating controls:
0LFURSKRQH VZLWFK
)LJXUH  $0* 2SHUDWLQJ &RPSRQHQWV
Table 20 contains instructions for operating the AMG-1.
To Do this
Turn on speakers Toggle the
until the
on.
Turn off speakers Toggle the
until the
off.
Adjust the volume Turn the
of the AMG-1
VOLUME CONTROL
speaker
Page through the 1. Press the
system switch.
2. Press the switch on the
side of microphone.
3. Speak into the
microphone.
Select the speaker Select the control switches on
circuit for paging the respective ACM
annunciator points or the
VCM-4 module connected to
the AMG-1.
7DEOH  $0* 2SHUDWLQJ ,QVWUXFWLRQV
$// &$//
Comments
switch The
ALL CALL ALL CALL
LED goes speaker circuits (that are not switch
ALL CALL
inhibited) or a specific programmed
group of speakers. For dual-channel
applications, press the
switch on either AMG.
switch If an alarm exists, speaker circuits
ALL CALL
LED goes remain on until you turn them off or
ALL CALL
reset the system.
If necessary, turn the volume down
LOCAL SPEAKER
knob. to prevent feedback during paging.
Talk loudly enough to cause the
ALL CALL
green
the
AUDIO LEVEL
for 15 seconds, a system trouble can
result and a default tone is generated
by the AMG the
is lighted by the proper volume of
sound at the microphone or until the
ALL CALL
button on the AMG-1.
Refer to the AFC-600 Installation
and Programming Manuals for
instructions.
 9RLFH $ODUP 6\VWHPV
VZLWFK
/RFDO 6SHDNHU
9ROXPH &RQWURO
- ² WDSH UHFRUGHU
LQSXW
switch activates all
ALL CALL
LED to light.If
AUDIO LEVEL
LED remains off
LED
AUDIO LEVEL
LED is turned off by the
55