How To Operate A Control Panel With A Fire Alarm; How The Control Panel Indicates A Fire Alarm - Notifier AFC-600 Operating Manual

How to Operate a Control Panel with a Fire Alarm

+RZWR2SHUDWHD&RQWURO3DQHOZLWKD)LUH$ODUP
AFC-600 Operations PN 51033:A 3/8/99
Technical Manuals Online! - http://www.tech-man.com
+RZWKH&RQWURO3DQHO,QGLFDWHVD)LUH$ODUP
When an initiating device (detector, XP5-M or other monitor module) activates, the
control panel indicates a fire alarm. Figure 6 shows how the control panel indicates a
fire alarm:
6HQGV DQ $ODUP PHVVDJH WR LQVWDOOHG SULQWHUV
7%
7%
7%
$/$50 38// 67$7,21 ,&8 :(67 :,1*
9,6,7256 /281*(
)LJXUH  7KH &RQWURO 3DQHO ZLWK D )LUH $ODUP
When an initiating device activates a fire alarm, the control panel does the following:
• Produces a steady audible tone
• Activates the System Alarm relay (MPS-6, TB3) and flashes the
• Displays a Type Code that indicates the type of device that activates the fire alarm
• Displays in the status banner on the LCD display, along with information
ALARM
specific to the device, as shown in Figure 7
$/$50 38// 67$7,21 ,&8 :(67 :,1*
9,6,7256 /281*(
)LJXUH  6DPSOH )LUH $ODUP 'LVSOD\
• Sends an Alarm message to the LCD display, History buffer, and installed printers,
terminal mode LCD-80s, and CRT-2s
• Latches the control panel in alarm. (You cannot return the control panel to normal
operation until you correct the alarm condition and reset the control panel)
• Initiates any Control-By-Event actions
• Starts timers (such as Silence Inhibit, Auto Silence)
• Activates the general alarm zone (Z00)
 +RZ WR 2SHUDWH WKH &RQWURO 3DQHO
6HQGV DQ $ODUP PHVVDJH WR LQVWDOOHG &57V
6HQGV DQ $ODUP PHVVDJH WR LQVWDOOHG WHUPLQDO
PRGH /&'V
 30 78(   0
6WDWXV EDQQHU $/$50
7\SH &RGH RI LQLWLDWLQJ GHYLFH
 30 78(   0
'LVSOD\V DQ $ODUP
PHVVDJH RQ WKH /&'
GLVSOD\
)ODVKHV WKH
),5(
/('
$/$50
LED
FIRE ALARM
38// 67$7,21
17