Safety Precautions (By The Operator) - ferrotec CARRERA Operation Manual

High Voltage Power Supply
Type: CARRERA
3.4 Safety Precautions
(by the Operator)
Version 1.3_15 EN
11 Mains supply
12 Connection Master/Slave: Control signal
13 Connection Master/Slave: Interlock signal
The operator must:
instruct his operating and maintenance personnel in the use
-
of the safeguards of the electron beam evaporator and
ensure the safety precautions are being observed including
-
the use of personal protective equipment.
The owner must ensure that entry to the hazard area of the
-
machine (into which the high voltage power supply has been
built) by unauthorized persons (no operating and
maintenance personnel) is prevented. The minimum
clearances stated in DIN EN ISO 13857 are to be complied
with when installing the high voltage power supply.
The high voltage power supply may only be operated when
-
the safety devices of the machine into which the high voltage
power supply has been built have been activated. The person
setting up the entire machine must ensure that through
suitable technical measures.
The cutting off of the energy sources is to be done in such a
-
way technically that the switching-off procedure described
under section 4.5 can be complied with.
This instruction handbook must be kept in a safe place for future
reference. The frequency of inspections and checks must be
observed.
The work described in this instruction handbook is explained in
such a way that
the chapters on operation and modes of operation can be
-
understood by an instructed person and
those on transport, installation and assembly, maintenance
-
and troubleshooting by a skilled person.
The chapters on transport, installation and assembly,
maintenance and troubleshooting are intended for skilled
persons only. Work described in these chapters may only be
carried out by such skilled persons.
17