Telebit WorldBlazer User Manual page 63

C-2
For leased-line applications, configure the modems as
shown in Table C-2.
Table C-2. Leased-Line Modem Configuration
Originate Modem Answer Modem
S7=255 S7=255
S50=7 S50=7
SO=O SO=1
&Ll
&L 1
S94=0
S94=0
This configuration allows the modems to attempt a
V.32bis connection. If the user disconnects the call (by
entering the H or Z command, pressing the T
/D
switch, or
dropping DTR) or aborts the call before the connection is
complete, the modem does not attempt to reestablish the
connection.
You can enter leased-line operation by using the
following procedure. First, enter the configuration you
want from Table C-2 and save the setting to nonvolatile
memory by using the & W command. Then turn the
modem off and on to initiate automatic call establishment.
For additional information, refer to Chapter 3, AT
Command Descriptions, in the reference manual for
complete descriptions of the commands used in the
Telebit Extended AT command set. Refer to Chapter 4,
AT Register Descriptions, in the reference manual for
complete descriptions of the registers used in the Telebit
Extended AT command set.
Leased-Line Considerations 90257-01