Examining An S Register; Establishing A Connection; Using The Dial Command - Telebit WorldBlazer User Manual

Examining an S Register
The? command allows you to inspect the contents of a
given S register. The following example uses the SSl
register:
AT S51?
The
&
V command allows you to view the current
configuration.
Establishing a Connection
This section describes the procedures used to establish a
connection.
Using the Dial Command
3-10
Use the Dial (D) command to place a call through the
modem. When you enter the D command, the modem
stops processing commands, dials the number indicated,
and waits for a connection.
If no connection occurs within the specific period of time
defined by the S7 register (normally 60 seconds), the
command is canceled, and the modem returns to
command mode (waits for the next command).
The following example shows you how to call another
modem using tone dialing:
AT DT 555-6789
The next example shows you how to have the modem dial
through a PBX using pulse dialing (DP9), wait for a dial
tone for an outside line (W), dial a long distance telephone
number, wait for 8 seconds (",,) then switch to tone
dialing
(T)
to charge the call to a telephone credit card:
AT DP9 W 0-408-555-6789""T123-456-7890-1234
The Basics
90257-01