Configuring Mac Filter - INSYS MoRoS ADSL 2.1 PRO Manual

Functions
13.1.5

Configuring MAC Filter

A MAC filter can be enabled in the MoRoS ADSL 2.1 PRO. This will then only
accept packets at the local Ethernet interface that come from network devices that
are explicitly permitted in the filter.
Configuration via the web interface
In order to enable the MAC filter, check in the menu "Basic Settings" on
the page "MAC filter" the checkbox "Activate MAC filter".
In order to enter a new source MAC address, enter this into the "Allow
new source MAC" field. Save the entry by clicking "OK".
In order to delete an existing MAC address, check under "Allowed source
MAC addresses" the checkbox of the route(s) to be deleted.
Save your settings by clicking "OK".
46
Note
Loss of availability!
If the MAC address of the computer that is used for
configuration is not entered, no further configuration will
be possible any more.
It is necessary that you enter the MAC address of the
computer that is used for configuration into the list of
allowed source MAC addresses before activating the MAC
filter.
MoRoS ADSL 2.1 PRO