VEGAPULS 64 • HART and accumulator pack
Fig. 7: Adapter flange
1
Connection screw
2
Adapter flange
3
Process seal
4.3
Mounting preparations, mounting strap
The mounting strap is supplied unassembled (optionally) and must be
screwed to the sensor before setup with three hexagon socket screws
M5 x 10 and spring washers. Max. torque, see chapter "Technical
data". Required tools: Allen wrench size 4.
There are two different variants of screwing the strap to the sensor,
see following illustration:
Fig. 8: Mounting strap for screwing to the sensor
1
For angle of inclination in steps
2
For angle of inclination, infinitely variable
Depending on the selected variant, the sensor can be rotated in the
strap:
•
Single chamber housing
– Angle of inclination in three steps 0°, 90° and 180°
– Angle of inclination 180°, infinitely variable
•
Double chamber housing
– Angle of inclination in two steps 0° and 90°
– Angle of inclination 90°, infinitely variable
1
2
3
1
2
4 Mounting
17