Shaft And Front Bearing - JLG 660SJ Service And Maintenance Manual

8. Press front shaft bearing (15) on shaft (16). Press bearing
on shaft with lettering facing out. Lubricate bearing roll-
ers. Install snap-ring (17) on shaft.
15. Front Shaft Bearing
16. Shaft
Figure 3-35. Shaft and Front Bearing
9. While holding swashplate in place, turn housing on its
side. Install the install shaft/bearing assembly into hous-
ing from flange end. Install snap-ring (18).
10. Verify swashplate and bearings are properly seated.
Install cylinder kit (19) on shaft. Install with slippers fac-
ing swashplate. Rock the shaft to align block splines and
slide cylinder kit into place. Orient motor with shaft
pointing downward and verify cylinder kit, swashplate,
journal bearings, and servo piston are properly installed.
19
19. Cylinder Kit
Figure 3-36. Cylinder Kit Installation
3121298
15
16
17
18
17. Snap Ring
18. Snap Ring
SECTION 3 - CHASSIS & TURNTABLE
11. Lubricate and install servo spring (20) and minimum
angle stop (21) in housing bore.
20. Servo Spring
21. Minimum Angle Stop
Figure 3-37. Servo Spring and Minimum Angle Stop
– JLG Lift –
21
20
3-29