Shaft & Front Bearing - JLG 660SJ Service And Maintenance Manual

SECTION 3 - CHASSIS & TURNTABLE
.
35
35. Inner Snap Ring
36. Snap Ring
Figure 3-30. Shaft & Front Bearing
2. Remove inner snap ring (35) and shaft/bearing assembly.
3. Remove snap-ring (36) retaining shaft front bearing. Pull
bearing (37) off shaft (38).
3-24
36
37
38
37. Bearing
38. Shaft
– JLG Lift –
Lift Here
43
39. Swashplate
40. Servo Piston
41. Piston Seal
Figure 3-31. Swash Plate & Servo Piston
4. Turn housing over and remove swashplate (39) by lifting
on end opposite servo lever.
5. Remove servo piston (40). Remove piston seal (41) and
O-ring (42) from servo piston. Discard seal and O-ring.
6. Remove journal bearings (43) from housing. Note loca-
tion and orientation of each bearing for reassembly.
39
40
42
41
42. O-ring
43. Journal Bearings
3121298