JLG 660SJ Service And Maintenance Manual page 284

SECTION 6 - JLG CONTROL SYSTEM
Configuration Digit
TILT:
8
Note: Any of the selections above will light the tilt lamp when a tilted condition occurs and will sound the platform alarm when
the machine is also above elevation.
JIB:
9
4 WHEEL STEER:
10
STOUCH/SKY-
:
GUARD
11
GEN SET/WELDER:
12
GEN SET CUTOUT:
13*
* Only visible if Gen Set / Welder Menu selection is not 0.
6-34
Table 6-5. Machine Configuration Programming Information
Number
1 5 DEGREES: Reduces the maximum speed of all boom functions to creep
when tilted more than 5 degrees and above elevation; also reduces drive
speed to creep.
2 4 DEGREES: Reduces the maximum speed of all boom functions to creep
when tilted more than 4 degrees and above elevation; also reduces drive
speed to creep.
3
3 DEGREES: Reduces the maximum speed of all boom functions to creep
when tilted more than 3 degrees and above elevation; also reduces drive
4 speed to creep.
4 DEGREES + CUT: Reduces the maximum speed of all boom functions to
creep when tilted more than 4 degrees and above elevation; also disallows
5 tower lift up, tower telescope out, drive, main telescope out and main lift up.
3 DEGREES + CUT: Reduces the maximum speed of all boom functions to
creep when tilted more than 3 degrees and above elevation; also disallows
tower lift up, tower telescope out, drive, main telescope out and main lift up.
0 NO: No Jib installed.
1 YES: Jib installed which has up and down movements only.
0 NO: No four-wheel steer installed.
1 YES: Four wheel steer installed
0 NO: No soft touch or SkyGuard system installed.
1 SOFT TOUCH: Soft touch only installed.
2 SKYGUARD: SkyGuard only installed.
3 BOTH (CUTOUT) - Soft touch and SkyGuard installed.
0 NO: No generator installed.
1 BELT DRIVE: Belt driven setup
0 MOTION ENABLED: Motion enabled when generator is ON.
1 MOTION CUTOUT: Motion cutout in platform mode only.
Description
– JLG Lift –
Default
Number
1
0
0
0
0
0
3121298