JLG 660SJ Service And Maintenance Manual page 283

Configuration Digit
NOTE: Machine configuration must be completed before any personality settings can be changed. Changing personality set-
tings first and then changing the model number of the machine configuration will cause personality settings to return to
default
MODEL NUMBER:
1
MARKET:
2
ENGINE:
3
FLYWHEEL TEETH:
4
GLOW PLUG:
5
STARTER LOCKOUT:
6
ENGINE SHUT-
DOWN:
7
3121298
Table 6-5. Machine Configuration Programming Information
Number
0 No Model
4 600S
0 ANSI USA
1 ANSI EXPORT
2 CSA
3 CE
4 AUSTRALIA
5 JAPAN
8 DEUTZ F4 TIER1: Deutz BF4M1011 Diesel (Tier 1)
9 DEUTZ F4 TIER2: Deutz BF4M2011 Diesel (Tier 2)
12 DEUTZ ECM: Engine Control Module
13 CAT Engine
0 133 TEETH: 133 flywheel teeth.
1 110 TEETH: 110 flywheel teeth.
0 NO GLOW PLUGS: No glow plugs installed.
1 AIR INTAKE: Glow plugs installed in the air intake on the manifold.
2 IN-CYLINDER: Glow plugs installed in each cylinder.
0 DISABLED: Automatic pre-glow time determined by ambient air tempera-
ture; engine start can be attempted at any time during pre-glow.
1 ENABLED: Automatic pre-glow time determined by ambient air tempera-
ture; engine start is NOT permitted until pre-glow is finished.
0 DISABLED: No engine shutdown.
1 ENABLED: Shutdown engine when coolant temperature is greater than
110°C or oil pressure is less than 8 PSI.
SECTION 6 - JLG CONTROL SYSTEM
Description
– JLG Lift –
Default
Number
0
1
0
14
1
2
0
1
6-33