JLG 660SJ Service And Maintenance Manual page 285

Configuration Digit
H & T LIGHTS:
14
CABLE SWITCH:
15*
* Certain market selections will alter default setting.
LOAD SYSTEM:
16*
* Only visible under certain market selections.
* Certain market selections will limit load system options or alter default setting.
LOAD SENSOR:
17*
* Only visible under certain market selections.
* Certain market selections will limit load system options or alter default setting.
3121298
Table 6-5. Machine Configuration Programming Information
Number
0 NO: No head and tail lights installed.
1 YES: Head and tail lights installed.
0 NO: No broken cable switch installed.
1 YES: Broken cable switch installed.
0 NO: No load sensor installed.
1 WARN ONLY: Functions in creep, overload lamp lit, platform alarm beeps (5
sec ON, 2 sec OFF).
2 CUTOUT PLATFORM: All functions cutout, overload lamp lit, platform alarm
beeps (5 sec ON, 2 sec OFF).
3 CUTOUT ALL: All functions cutout, flash overload light (500mS on, 500mS
off ), platform alarm beeps (5 sec ON, 2 sec OFF).
4 SPECIAL 1: Functions in creep, overload lamp lit, disables main telescope out
& main lift up, platform alarm beeps (5 sec ON, 2 sec OFF).
0 1 ON ROTATOR: Use the on-board load sensor for all models except those
which use the Leveling Platform Module.
1 4 UNDER PLATFORM: Use the EIM for load sensing.
SECTION 6 - JLG CONTROL SYSTEM
Description
– JLG Lift –
Default
Number
0
0
0
1
6-35