JLG 660SJ Service And Maintenance Manual page 173

11. Before removing piston (3), mark housing (1) ring gear in
relation to piston O.D. gear. There should be timing
marks on housing (1) ring gear, piston (3), and shaft (2).
12. To remove piston (3), use a rubber mallet and plastic
mandrel so piston is not damaged.
3121298
13. At the point when piston gear teeth come out of
engagement with housing gear teeth, mark piston and
housing with a marker as shown.
14. Remove O-ring (204) and backup ring (207) from end
cap (4) and set aside for inspection.
– JLG Lift –
SECTION 4 - BOOM & PLATFORM
4-23