JLG 660SJ Service And Maintenance Manual page 286

SECTION 6 - JLG CONTROL SYSTEM
Configuration Digit
FUNCTION CUT-
OUT:
18*
* Only visible under certain market selections.
* Certain market selections will limit function cutout options or alter default setting.
GROUND ALARM:
19*
* Certain market selections will alter default setting.
DRIVE:
20*
* Only visible under certain market selections.
DISPLAY UNITS:
21*
* Certain market selections will alter default setting.
LEVELING MODE:
22*
* Only visible on 800S models.
DRIVE CONTROL:
23
BOOM CONTROL:
24
6-36
Table 6-5. Machine Configuration Programming Information
Number
0 NO: No drive cutout.
1 BOOM CUTOUT: Boom function cutout while driving above elevation.
2 DRIVE CUTOUT: Drive cutout above elevation.
3 DRIVE CUT E&T: Drive cutout above elevation and tilted.
0 NO: No ground alarm installed.
1 DRIVE: Travel alarm sounds when the drive function is active (Option).
2 DESCENT: Descent alarm sounds when lift down is active (Option).
3 MOTION: Motion alarm sounds when any function is active (Option).
0 4 WD: Four wheel drive.
1 2WD: Two wheel drive.
2 2WD W/2-SPEED: Two wheel drive with two-speed valve.
0 IMPERIAL: DEG F, PSI, LBS
1 METRIC: DEG C, KPA, KGS.
0 ALL: Platform level with all functions.
1 LEVEL LIFT /TELESCOPE: Platform level on lift and telescope only.
0 NORMAL: Drive coils are energized from the Ground Module.
1 PROPULSION: Drive coils are energized from the Propulsion Module.
2 ENHANCED: Drive coils are energized from the Ground Module and the
ground side of the drive coils are brought back to current feedback returns.
0 NORMAL: Boom control coils are energized from the Ground Module.
1 ENHANCED: Boom control coils are energized from the Ground Module and
the ground side of the drive coils are brought back to current feedback
returns.
Description
– JLG Lift –
Default
Number
0
3
0
0
0
2
0
3121298