GBC F-60H Operation & Maintenance Manual page 94

Applications
Materials - Lo-Melt over-lamination of a mounted image
Top material : Roll of Lo-Melt film
Bottom material : N/A
Other material (s) : A pre-mounted image to a board, leader board and trailer board
Motor Direction
Motor Speed
3
2
1
Roller Pressure
Notes : The laminate should not exceed the pre-mounted image by more than 3 in. (7.6 cm).
Speed will be determined by what is comfortable with the operator. Pressure is dependent
on the substrate. Do not crush the substrate. Use a leader board to start the process and
finish with a trailer board. Stopping on the image will aleave an impression on the board
or image. Heat is dependent on the thickness of the film. Refer to helpful hints for Lo-Melt
films and mountng.
Page 6 - 32
PROCESS CONTROL CHART
5 6
4 7
8
9
10
RANGE
F 60 H Operation and Maintenance Manual
Heater
Upper Roller Temperature
CAL 3200
RANGE
CAL 3200
© April 2001 General Binding Corporation