GBC F-60H Operation & Maintenance Manual page 107

F 60 H Operation and Maintenance Manual
c) Set motor direction to REV.
(reverse)
d) For pressure sensitive adhesives: put the rubber
gloves on and use isopropyl alcohol and a
terry cloth towel to rub the adhesive off.
Excessive pressure can destroy the silicone
layer by pressing to hard or scrubbing
too long in one spot.
e) For thermal adhesives: while the laminator is at
normal operating temperature, put on the rubber
gloves and use the rubber cement eraser. This
allows the eraser to bead up the adhesive.
f) Wipe away the beads with isopropyl alcohol
and a cotton terry cloth.
© April 2001 General Binding Corporation
(forward)
CAUTION
CAUTION
Exercise care when cleaning the laminating
rollers with 80% isopropyl alcohol:
Ÿ Use only in a well ventilated area
Ÿ Wear rubber gloves
Ÿ Use only on cool rolls
C L E A N I N G H E A T E D R O L L E R S C A N
I G N I T E T H E F U M E S !
CAUTION
Do NOT pick or pull heat activated adhesive
off the rolls when they are cold. You can
cause irreparable damage to the
laminating rolls.
W A R N IN G
W h en op erating th e lam inator u sin g the
footsw itch, keep hand s and fin gers
aw ay from th e n ip of the rollers.
Y ou m ay b e C R U S H E D or B U R N E D !
d) Use the footswitch to rotate the rollers when
finished cleaning that area.
Maintenance
Page 8 - 3