GBC F-60H Operation & Maintenance Manual page 57

F 60 H Operation and Maintenance Manual
Load film
a) Adjust the core grips so they are close to the edge
of the roll of film being used but remain inside the
core when the roll of film is positioned on the
unwind shaft.
R o ll o f film
C o re c h u c k C o re s u p p o rt
b) Lift up on the clevis pin to the unwind shaft located
in the unwind support saddle.
C le v is p in
U n w in d s u p p o rt s a d d le
c) Swing the unwind shaft out far enough to slide the
roll of film completely on.
© April 2001 General Binding Corporation
N ever leave the unw ind shaft out of the
unw ind support saddle unless loading
d) Swing the unwind shaft completely back into the
unwind support saddle and push the clevis pin
down.
C o re c h u c k
e) If using the lower unwind, center the upper roll of
film on the laminating rollers.
( C )
W hen using tw o rolls on the m achine,
ensure the film w idths are identical.
E xposed adhesive can cause com plications.
f) Repeat steps a) through c) to load film on the
lower unwind shaft.
W AR N IN G
or unloading film .
C le v is p in
U n w in d s u p p o rt s a d d le
( A )
( B )
( A ) - ( B ) / 2 = ( C )
C AU T IO N
Operations
( C )
Page 5 - 7