F 60 H Operation and Maintenance Manual
Sharp edges on a substrate
should be filed sm ooth.
Sharp edges can C U T the rollers!
d) Position the substrate center of the feed table
between the two rollers.
substrate
e) Lower the upper main roller until it makes
contact with the substrate. Lower enough to
apply sufficient pressure without crushing the
substrate.
© April 2001 General Binding Corporation
C AU T IO N
IN F O R M AT IO N
E xcessive pressure w ill cause the
substrate to bow or flatten.
S u ffic ie n t
IN F O R M AT IO N
D ensity of the substrate w ill determ ine the
am ount of pressure you m ay use.
f) Press the motor engage/ disengage to engage or
step on the footswitch to back the board out
from the nip.
(disengage)
engage)
f) The nip is now set for the substrate being used.
Remember to set the motor direction to FWD.
Operations
E x c e s s iv e
Page 5 - 11