GBC F-60H Operation & Maintenance Manual page 48

Installation
d) Rotate the speed dial to a setting greater than 1.
4
3
2
1
e) Press the motor engage/ disengage to ENGAGE.
(disengage)
f) Press the temperature on/off to ON.
(off)
g) Press one of the four E-STOPs.
Page 4 - 14
5 6
7
8
9
10
(engage)
(on)
F 60 H Operation and Maintenance Manual
h) The bottom main roller stops turning, the power
indicator light goes out, the display on the
temperature controller unit goes out.
i) Turn the E-STOP 1/4 turn counter clockwise to
unlatch.
j) Repeat steps b) through i) for the remaining
three E-STOPs.
PHOTO-EYE
a) Cut a piece of 1/2 inch ( 1.3 cm ) thick foam
board to 4 inches x 6 inches. ( 10 cm x 15 cm )
This piece will be referred to as the "finger board".
D o not use a hard substrate or a substrate
w ith sharp edges. Y ou m ay cause dam ge to
the lam inating rollers.
© April 2001 General Binding Corporation
C AU T IO N