GBC F-60H Operation & Maintenance Manual page 49

F 60 H Operation and Maintenance Manual
b) Ensure all E-STOPs are in the unlatched position
and remove the pressure plate from the front feed
table.
c) If the power indicator on the control panel is not
illuminated, press Reset.
Reset
P O
W
E R
d) Set the motor direction to FWD.
(reverse)
e) Lower the main roller to initial contact ( one bar
on the pressure display is illuminated ).
© April 2001 General Binding Corporation
(forward)
f) Press the motor engage/ disengage to ENGAGE.
(disengage)
g) Slide the "finger board" on the front feed table
towards the nip about 10 in. ( 25 cm ) from the
control side.
fin g e r b o a rd
h) The rollers should stop just before the finger
board can enter the roller nip.
i) Slide the finger board back away from the rollers
nip. Press the motor engage/ disengage to
ENGAGE.
(disengage)
Installation
(engage)
(engage)
Page 4 - 15