GBC F-60H Operation & Maintenance Manual page 80

Applications
Top material : Roll of Lo-Melt film
Bottom material : Roll of pressure sensitive adhesive
Other material (s) : prints
Motor Direction
Motor Speed
3
2
1
Roller Pressure
Notes : Speed will be dependent on the activation of the Lo-Melt adhesive. If the output
appears cloudy or milky, reduce the speed. Pressure will vary depending on the weight
and width of the image and laminate. For thinner laminates, use the 180 o F ( 82 o C ) and
for thicker films, use the 200 o F ( 93 o C ).
Page 6 - 18
PROCESS CONTROL CHART
Materials - Lo-Melt Decaling
5 6
4 7
8
9
10
RANGE
F 60 H Operation and Maintenance Manual
Heater
Upper Roller Temperature
CAL 3200
RANGE
CAL 3200
© April 2001 General Binding Corporation