GBC F-60H Operation & Maintenance Manual page 86

Applications
Top material : Roll of pressure sensitive laminate
Bottom material : N/A
Other material (s) : Images, leader board, trailer board and a pre-coated board
Motor Direction
Motor Speed
3
2
1
Roller Pressure
Notes : The leader board and trailer board should be the same width as the pre-coated
board. The laminate should not exceed the pre-coated board by more than 1 in. ( 2.54 cm ).
Do not use excessive brake tension for this application. Pre-coated board is reusable
since the laminate does not bond with the release liner from the pressure sensitive
adhesive. Speed should be comfortable for the operator. Pressure will vary depending on
the type of substrate. Heat is optional. Some heat will assist the flow of adhesive. Refer to
helpful hints for pressure sensitive films.
Page 6 - 24
PROCESS CONTROL CHART
Materials - PSA Single sided lamination ( sled method)
5 6
4 7
8
9
10
RANGE
F 60 H Operation and Maintenance Manual
Heater
Upper Roller Temperature
CAL 3200
RANGE
CAL 3200
© April 2001 General Binding Corporation