GBC F-60H Operation & Maintenance Manual page 74

Applications
Top material : N/A
Bottom material : N/A
Other material (s) : Image and a Pre-coated board
Motor Direction
Motor Speed
4
3
2
1
Roller Pressure
Notes: The image shoud not exceed the pre-coated board by more than 1 in. ( 2.5 cm ). If
the image is smaller than the precoated board, trim the board or pre-trim the release liner
around the image. Speed for mounting should be comfortable for the operator. Use the
footswitch for this application. Pressure will be dependent on the type of subtrate. No
heat is required for this application. Do not crush the substrate. Do not stop in the middle
of the run. Refer to helpful hints for mounting.
Page 6 - 12
PROCESS CONTROL CHART
Materials - Mounting an image
5 6
7
8
9
10
RANGE
F 60 H Operation and Maintenance Manual
Heater
Upper Roller Temperature
CAL 3200
RANGE
CAL 3200
© April 2001 General Binding Corporation