Table of Contents
Advertisement
Chapter 23: Network Time Protocol Server
Enabling Or Disabling A Network Time Protocol (NTP) Server
23.2 Enabling Or Disabling A Network Time Protocol
(NTP) Server
To configure your access point to use a network time protocol (NTP) server, first
enable the use of NTP, and then select the NTP server you want to use. (To shut
down NTP service on the network, disable NTP on the access point.)
Field
Network Time Protocol
(NTP)
NTP Server
23.3 Updating Settings
To update time settings:
1. Navigate to the Time tab page.
2. Configure the time settings as required.
3. Click the Update button to apply the changes.
250
Psion Teklogix 9160 G2 Wireless Gateway User Manual
Description
NTP provides a way for the access point to obtain and maintain its time from a server on the
network. Using an NTP server gives your AP the ability to provide the correct time of day in
log messages and session information.
For more information on NTP, see http://www.ntp.org.
Choose to either enable or disable the use of a network time protocol (NTP) server:
• To enable the NTP server, click Enabled.
• To disable the NTP server, click Disabled.
If NTP is enabled, select the NTP server you want to use.
You can specify the NTP server by host name or IP address, although using the IP address
is not recommended as these can change more readily.
Table 23.1 NTP Settings
Advertisement
Table of Contents
